Skip to content
Vet Tech Practice

Study topics / Laboratory procedures

Blood smears: how to make, stain and read a wedge smear

Spread a small drop of well-mixed anticoagulated blood with a second slide held at 30 to 45 degrees, air-dry it, and dip it through a quick Romanowsky stain. Do your 100-cell differential, platelet estimate and red cell morphology in the monolayer, and use the feathered edge to look for platelet clumps and large cells.

How to make a wedge blood smear, step by step

Make the smear as soon as you collect the sample, because blood stored in the tube changes over time. Gently rock the blood tube first so the cells are evenly spread, then work quickly: a drop left sitting for more than a few seconds lets cells settle before you spread it.[1],[5]

Put a small drop of blood near one end of a clean slide. Place the short edge of a second slide, the spreader, in front of the drop at an angle of about 30 to 45 degrees. Pull it back into the drop and let the blood run along its edge. Then push it forward along the slide in one fast, gentle, smooth motion, keeping even pressure and not lifting the spreader until you reach the end.[1],[3]

Dry the smear quickly by waving it in the air or with a hair dryer. Never heat fix it and never wipe it. Label the slide with the patient's identification.[1],[3],[4]

What a usable smear looks like[1],[4]

FeatureWhat you want
SurfaceSmooth, with no ripples from a jerky push and no holes
LengthCovers at least two thirds of the slide
FinishEnds before the far end of the slide in a feathered edge with a rainbow sheen
ThicknessThin enough that part of it is one red cell thick

Fixing a smear that is too thick or too thin

Drop size, spreader angle and speed all change the result. If the smear is too thick or too short, try a lower spreader angle or a smaller drop. If it is too thin or too long, raise the angle. Streaks usually mean the spreader edge needs cleaning.[3]

The patient's blood matters too. For an anemic animal, increase the angle so the blood spreads properly. For a hemoconcentrated animal, most often a dehydrated one, decrease the angle.[1]

How to stain a blood smear with a quick Romanowsky stain

Most stains used in veterinary medicine are Romanowsky-type quick stains such as Diff-Quik. These kits only need you to dip the slide through three solutions in turn, starting with a fixative. Follow the manufacturer's directions for timing. A thin smear may need less time, and a thick one may need longer, especially in the last (blue) solution.[4],[5],[6]

Make sure the slide is fully dry before it goes in, since water can remain even when it looks dry. No extra fixing is needed before you stain an air-dried smear.[6]

Keep the jars tightly capped when not in use, so the solutions do not evaporate and the fixative does not pick up water from the air. Do not top off a low jar. When the level drops or the staining gets worse, empty, clean and dry the jars and refill them with fresh stain.[5]

Poorly kept stain causes two common artifacts. Water in the fixative leaves refractile marks that flash as you focus up and down and can be mistaken for red cell inclusions. Old stain or poor rinsing leaves stain precipitate, which you will see focused above or below the cells rather than level with them.[5]

The feathered edge, monolayer and body: where to look

A good smear from a healthy animal has three zones. The thick body is near the drop. The feathered edge is the thin far end of the smear. The monolayer lies between them, and there red cells and white cells are evenly spread.[1],[2]

Do your 100-cell white cell count, platelet estimate and red cell morphology in the monolayer. As you count, follow the curve of the monolayer rather than tracking straight across the slide.[1],[2]

Scan the feathered edge too. Large cells collect there, and it is where you check for platelet clumps. The body can hint at agglutination or rouleaux, but confirm either one in the monolayer.[1],[2]

How to do a manual differential count

In the monolayer, identify and tally 100 white cells by type. The white cells should be well spread, not bunched at the feathered edge. Your tally gives the percentage of each type. If you see nucleated red cells, record how many you see per 100 white cells as you go.[2],[7]

Percentages alone are not meaningful. Convert each one to an absolute count by multiplying the percentage by the total white cell count, and interpret the absolute numbers.[4],[7]

How to do a platelet estimate from a blood smear

Using the 100x oil immersion lens in the monolayer, count the platelets in 10 fields and average them. Multiply the average by 15,000 to get an estimated platelet count per microliter. Treat this as a rough guide, not an exact count.[8]

Always look for platelet clumps, because clumps lower the platelet count whatever the method. Scan the slide for clumps before you report platelet numbers as low. An estimate inside the species reference interval is reported as adequate.[4],[8]

Recognising the white blood cell types

On a Romanowsky stain, each normal white cell has a few features that set it apart. Dog eosinophil granules vary a lot in size, number and shape, and in greyhounds and other sighthounds eosinophils may show no visible granules, only gray cytoplasm and vacuoles.[4],[9]

Normal white cells on a quick-stained smear[4],[9]

CellKey features
Segmented neutrophilLobulated nucleus; in many species, a constricted or knobbly nucleus rather than distinct lobes
Band neutrophilUnsegmented nucleus with smooth, parallel or nearly parallel sides
LymphocyteSmallest white cell; round nucleus with dense chromatin and a thin rim of light blue cytoplasm
MonocyteUsually the largest; round, kidney-shaped or lobulated nucleus with lacy chromatin; blue-gray cytoplasm, sometimes vacuolated
EosinophilProminent pink granules
BasophilBlue to purple granules on a Romanowsky stain; in cats, many small pale lavender granules; in dogs, a long ribbon-like nucleus and gray to lavender cytoplasm

Common red blood cell morphology terms

Judge red cell shape in the monolayer. Some changes are artifacts: spherocytes can appear falsely at the feathered edge, and echinocytes can come from stored blood or too much anticoagulant. To tell rouleaux from agglutination, dilute the blood with saline: rouleaux disperses, while agglutination usually does not.[2],[10]

Red cell terms you will use on a smear[4],[10]

TermMeaning
AnisocytosisVariation in red cell size
PolychromasiaPurple-tinged immature red cells; a few can be normal in dogs and cats
SpherocyteRed cell that has lost its biconcave shape
EchinocyteEvenly spiculated red cell, also called a burr or crenated cell
AcanthocyteIrregularly spiculated red cell, or spur cell
SchistocyteRed cell fragment
Target cell (codocyte)Bullseye red cell, recognised only in dogs
RouleauxStacking of red cells
AgglutinationThree-dimensional clumps of red cells
Heinz bodyRefractile or red inclusion, easier to see with new methylene blue
Howell-Jolly bodyNuclear remnant inside a red cell

Worked examples

Example 1: Short, thick smear from a dehydrated terrier

A dehydrated 9-year-old terrier's blood looks dark and thick. Your first smear stops a third of the way along the slide with no feathered edge.

  1. Step 1: Check the standard: a usable smear covers at least two thirds of the slide and ends in a feathered edge.[1]
  2. Step 2: Name the problem: the smear is too thick and too short.[3]
  3. Step 3: Adjust: use a smaller drop and a lower spreader angle, which also suits a hemoconcentrated patient.[1],[3]
  4. Step 4: Mix the tube again, spread the new drop at once, and air-dry the slide without heat.[1]

Answer

Remake the smear with a smaller drop and a lower angle. Thick blood and a too-short smear both call for decreasing the spreader angle.[1],[3]

Example 2: Platelet estimate for a Labrador

On a Labrador's smear, you move through the monolayer under oil and record platelets per field for 10 fields: 9, 12, 10, 14, 11, 8, 13, 10, 12 and 11.

  1. Step 1: Add the counts: 9 + 12 + 10 + 14 + 11 + 8 + 13 + 10 + 12 + 11 = 110.[8]
  2. Step 2: Average them: 110 divided by 10 fields = 11 platelets per field.[8]
  3. Step 3: Multiply: 11 x 15,000 = 165,000 platelets per microliter.[8]
  4. Step 4: Scan the feathered edge for clumps before reporting the number.[2],[4]

Answer

The estimate is about 165,000 per microliter. It is reported as adequate if it falls inside the reference interval for dogs, after you rule out clumps.[2],[4],[8]

Example 3: Turning a cat's differential into absolute counts

A cat's total white cell count is 14,000 per microliter. In 100 white cells you count 70 segmented neutrophils, 20 lymphocytes, 6 monocytes and 4 eosinophils, plus 2 nucleated red cells.

  1. Step 1: Check the tally adds to 100 white cells: 70 + 20 + 6 + 4 = 100. Record the 2 nucleated red cells per 100 white cells separately.[7]
  2. Step 2: Neutrophils: 0.70 x 14,000 = 9,800 per microliter.[4],[7]
  3. Step 3: Lymphocytes: 0.20 x 14,000 = 2,800. Monocytes: 0.06 x 14,000 = 840. Eosinophils: 0.04 x 14,000 = 560.[4],[7]

Answer

The absolute counts are 9,800 neutrophils, 2,800 lymphocytes, 840 monocytes and 560 eosinophils per microliter. These, not the percentages, are what get interpreted.[4],[7]

Common mistakes

Practise it

Sources

  1. [1]Burton and Lalande, Clinical Veterinary Diagnostic Laboratory (LibreTexts), 6.2: Blood Smear Procedure
  2. [2]Burton and Lalande, Clinical Veterinary Diagnostic Laboratory (LibreTexts), 6.1: Preparing a Diagnostic Blood Smear
  3. [3]Texas A&M Veterinary Medical Diagnostic Laboratory, Proper Blood Smear Preparation
  4. [4]Merck Veterinary Manual, Clinical Hematology (private practice laboratory)
  5. [5]Cornell eClinPath, Sample collection (hematology)
  6. [6]Cornell eClinPath, Sample collection (cytology)
  7. [7]Cornell eClinPath, White blood cell count
  8. [8]Cornell eClinPath, Platelet count
  9. [9]Cornell eClinPath, Normal leukocytes
  10. [10]Cornell eClinPath, Red blood cell quick guide

Checked against the sources listed, November 21, 2026. Spotted an error? Email support and it goes in the corrections log.

One order, 90 days, nothing renews

Two free tests of 25 questions to try first. Paid access adds 476 practice questions and three timed mock exams, written up the same way.

OrdersVet Tech Practice · 90-day pass

  • 476 practice questions across all 10 VTNE domains, by domain or mixed. Tutor mode explains as you go; timed mode saves feedback for the end.
  • 3 timed mock exams 170 questions each, 3 hours on a clock that keeps running, with different questions in each and none shared with practice.
  • Every answer explained with a note on each wrong option and the source it was checked against.
  • Results by domain and a full answer review after each mock, plus bookmarks and daily goals.
  • Sign in by email link with no password, on any device.

Duration and cost

$119USD

  • One payment, 90 days of access
  • No subscription, nothing to cancel
  • Full refund within 7 days if you have answered fewer than 50 questions and not started a mock
Or try 25 free questions first
  • Buyers in Canada pay GST/HST on top. Both free tests stay free.
  • The three mock exams have different questions. Once you have taken all three, a retake repeats questions you have seen.
  • Scores are practice counts, not a prediction of your VTNE result.
  • Secure checkout by Stripe. Your card statement shows TENSORHUB, the company that runs this site. By buying you agree to the terms.